Mix/Ratio 1:1
Solids Content 90%
Pot Life 15-20 Minutes
Tack Free 2-5 Hours
Foot Traffic 3-6 Hours
Heavy Traffic 24-48 Hours
Re-Coat Window 2-16 Hours
Dry Appearance Clear Glossy Finish
VOC Content Less Than 51 Grams/Liter Mixed


If mixing less than a full kit, mix Part A and Part B separately with a stir stick, or low-speed mixer to ensure uniform distribution of all ingredients. In a clean mixing container, blend 1 Part A and 1 Part B using a drill mixer for 2-3 minutes. Avoid creating a vortex in the material which could introduce air and/or moisture content to the mixture. Do not mix more than can be applied within the usable pot life time frame. Can be thinned with Xylene.

*Coverage Rates

First Coat – Direct to Concrete: 200 – 275 ft per gallon
Second Coat – Over Existing Coating: 250 – 350 ft per gallon
Media (Flake Floors, etc.) – Over Existing Coating: 175 – 225 ft per gallon

*Coverage rates may vary depending upon surface porosity, texture, application method, and prior coating application. Excessive build-up should be avoided.

Epoxy Flake/Chip Floors

Poly FX 90 is specifically designed as a durable topcoat. It can also be used as a base coat and is an excellent medium to broadcast flakes/chips in. It is recommended that you apply 2 or more coats of Poly FX 90 to flake floors.


As a base coat, spread material evenly using a flat or notched squeegee at 200 -275 square feet per gallon and back roll using a shedless 3/8″ nap roller cover. The object is to completely seal off the concrete surface prior to applying flakes.

As a top coat, apply the material directly on the floor and use a flat, flexible squeegee to evenly spread. Backroll using a 3/8″ roller. Do not allow material to puddle.


If possible, recoat within the suggested recoat window located above. Apply additional coats in the same manner as the first coat. Note that higher substrate, air, and material temperatures as well as excessive humidity may greatly reduce the acceptable recoat window of this product. When working in higher temperatures, always recoat as early in the recoat window as possible to avoid failure between coats. If recoating outside the suggested recoat window or beyond 24 hours, sand using a 60-120 grit sanding screen to ensure adequate adhesion between coats. Vacuum dust thoroughly, rinse with clean water, and remove excess water with a wet/dry vacuum or floor scrubber. Allow the surface to dry completely prior to application of the coating. Where applicable and with adequate ventilation, wipe the surface with acetone and a microfiber dust mop.

Caution: Acetone FX is extremely flammable! If using acetone follow all safety precautions, make sure no pilot lights, open flames, sources of static electricity, sparks, or extreme heat sources are present. Use the recommended personal protection for Acetone FX.